KK2.0 Multi-Rotor Control Board with LCD.


This fabulous kk2.0 multi-rotor control board changes the way you program your aircraft, the LCD screen and built in software makes install and setup easier than ever. a host of multi-rotor craft types are per-installed.  simply select your craft type, check motor layout/propeller direction, calibrate your ESC and radio and your ready to go! all of which is done with easy to follow on screen prompts!

    The original kk gyro system has been updated to an incredibly sensitive dual chip 3 axis gyro and single chip 3 axis accelerometer system making this the most stable kk board ever and allowing for the addition of auto-level function. At THE heart of the kk2.0 is and Atmel Mega324PA 8-bit AVR RISC-BASED microcontroller with 32k of memory. and additional 2 motor output channels have been added to the kk2.0 allowing for a total of 8 motor to be controlled (Octocopter). A handy Piezo buzzer is also included with the board for audio warning when activating and deactivating the board.

      If your new to Multi-rotor flight or have been unsure about how to setup a kk board then thee kk2.0 was built for you. The 6 Pin USBasp avr programming interface ensures future software updates will be quick and easy.


  • Size:---------- 50.5mm x 55.5mm x 12mm
  • Weight: ---------- 21gram (inc piezo busser)
  • IC: ---------- Atmega324PA
  • Gyro: ---------- InvenSense inc.
  • Program Cable incase of damage LCD. not included
  • Accelerometer: ---------- Anologue Devices inc.
  • Auto-level: ---------- yes
  • Input voltage: ---------- 4.8-6.0v
  • AVR interface: ----------Standard 6 pin.
  • Signal from receiver: ---------- 1520us (5 CHANNELS)
  • Signal to ESC: ---------- 1520us

Pre-installed firmware.

  • Dualcopter
  • Tricopter
  • Y6
  • Quadcopter +
  • Quadcopter x
  • Hexcopter +
  • Hexcopter x
  • Octocopter +
  • Octocopter x
  • X8 +
  • X8 x
  • H8
  • H6
  • V8
  • V6
  • Aero 1S Aileron
  • Aero 2S Aileron
  • Flying wing
  • Singlecopter 2M 2S
  • Singlecopter 1M 4S
  • (Custom Mix via the "Mixer Editor" option)

The mixer editor allows you to adjust where and how much signal the motors receive from stick input and sensors. This allows you to create and configuration possible with up to 8 motors or servos.


Sold Out
  • Model: TRAKK20CB01
  • Shipping Weight: 0.99kg
  • 0 Units in Stock

This product was added to our catalog on Thursday 27 December, 2012.

1055 Expression #1 of ORDER BY clause is not in GROUP BY clause and contains nonaggregated column 'tranamax_zc1.o.date_purchased' which is not functionally dependent on columns in GROUP BY clause; this is incompatible with sql_mode=only_full_group_by
[select p.products_id, p.products_image from zen_orders_products opa, zen_orders_products opb, zen_orders o, zen_products p where opa.products_id = '229' and opa.orders_id = opb.orders_id and opb.products_id != '229' and opb.products_id = p.products_id and opb.orders_id = o.orders_id and p.products_status = 1 group by p.products_id order by o.date_purchased desc limit 6]